Thumper Elite 80 AH Battery Pack with internal vehicle isolator | Suits vehicles up to 2016

The Elite Thumper is equipped with every possible outlet you would need for a battery system

2 x Marine grade Cigarette outlets, 1 x Merit outlet, 1 x Dual USB outlet, 1 x Engel fridge outlet, 1 x 50Amp Anderson (input / output), 1 x 175 Amp Anderson and a unique 50Amp Anderson outlet used solely for vehicle charging. 

The unique battery pack offers an INTERNAL isolator built within the unit, which will eliminate the need to install an under bonnet isolator in your vehicle for charging.  

The Thumper is designed to run perfectly within vehicles with voltage sensitive alternators, or even low alternator outputs (suited for vehicles up to 2016 and prior)

Simply run a 6mm / 8mm charge lead (supplied) through the vehicle to the location of your Thumper ELITE with an in line fuse/circuit breaker and your job is done! 

The Elite will isolate itself completely from the main cranking battery without the need of installing an additional under bonnet isolator to the vehicle. This feature is a perfect option for company vehicles or newer vehicles where it is difficult to locate or link into an ignition activated source.

Unrivaled in its field - there is no better battery system than the THUMPER ELITE.  
(unit supplied with complete wiring and jumper leads)

This unit is perfect for vehicles dated 2016 and prior. *Some later model vehicles will also suit this model, however, we would advise you to phone our store direct on 08 8391 3121 to discuss your needs and the compatibility of the Elite and your vehicle.

Do you have a later model vehicle? No worries! Check out the Thumper Outback instead!

 

 

FEATURES:

·       DUAL USB

 The Thumper Elite is fitted with 1 x Dual USB outlet rated to min 2.5Amps at 5Volts. This socket will allow for fast recharge of any USB compatible appliances. Please note: The USB will only be powered when the volt meter gauge is on.

·       ENGEL FRIDGE OUTLET 

The Thumper Elite is fitted with an Engel Fridge socket. 

Whilst the Engel socket is designed primarily for Engel fridges due to the 2prong connection, this plug is now readily available on the market and can be used to adapt your existing appliance or fridge in order to utilise this connection. The Engel socket can be used as both an inlet or an outlet and is rated to approx 15Amp at 12V.

THE BEST FEATURE YET!

·       “50AMP VEHICLE CHARGE ONLY” ANDERSON – Fitted with In built isolator – rated to 50Amps

This 50Amp Anderson connector is linked to its very own internal isolator, built inside the Thumper Elite itself!

This outlet will allow you to connect a charge line through the vehicle, directly off the main battery with nothing but a circuit breaker in the line – The Elite will isolate itself completely without the need of installing an additional isolator to the vehicle. This feature is a perfect option for company vehicles or newer vehicles where it is difficult to locate or link into an ignition activated source.

The Elite will have a disconnect voltage of approx 12.7 Volts – it is at this point that the Elite will isolate itself from the charging source.

The  reconnect voltage of the Elite is approx 13.2Volts – making it the perfect companion for the newer vehicles with low alternator voltage or voltage sensitive alternators.

The “50Amp Vehicle charge only” line can be used with a DC charger if required, however, we have found with experience that many vehicles up to 2016 do not require the use of DC Chargers.

Whilst a battery that is rated to 30AH in capacity can charge through a Cigarette socket, these sockets will only provide approx 5 – 10Amps at maximum and this is usually due to the factory fitted cable. We do not recommend charging permanently through a cigarette socket and would instead recommend to fit the provided charging kit included with the Thumper.

·       50AMP INPUT / OUTPUT ANDERSON

This 50Amp Anderson can be used to directly link the Elite to another battery without isolation. The line will provide a continuous link to whatever it is connected to. This connection will allow you the option to parallel link batteries to allow them to charge and discharge together as one. This connection may be used for running all accessories such as fridges, lighting, air compressors and anything 12 Volt.

Weight: 25kg

Length: 355mm

Width: 265mm

Height: 187mm